Example Of Setting The Pedal Function; Setting Ctl/Exp Functions Individually In Each Patch (Pedal Fx) - Boss GT-10 Owner's Manual

Chapter 4 Playing Sounds

Example of Setting the Pedal Function

Setting the parameters as shown below in the EXP1 PEDAL SETTING screen enables you to constantly use the GT-10's EXP
Pedal as a wah pedal.
Prefernc: System
Function: WAH
Min: 0
Max: 100

Setting CTL/EXP Functions Individually in Each Patch (Pedal FX)

This procedure sets the functions for the GT-10's controllers (CTL/EXP Pedal, EXP PEDAL SW) for individual patches.
* Set the Prefernc parameter of the CTL/EXP Pedal and EXP PEDAL SW (p. 137) settings to "Patch."
The MST/PDL FX screen appears.
1.
Select PEDAL/FX.
2.
The PDL:CTL/EXP screen appears.
3.
4.
P1: CTL1 Pedal
P2: CTL2 Pedal
P3: EXP PEDAL SW
P4: EXP Pedal
5. To save the settings, use the Write procedure (p. 42).
48
Make the parameter settings.
Pressing [DISPLAY MODE] toggles the display between Knob View and
List View.
• Some EXP Pedal parameters use multiple pages for the parameter
settings. You can use [ ] and [
• Each time [MASTER/PEDAL FX] is pressed, the EXP Pedal functions
alternate as shown below.
Parameter Functions Switched
FV Foot Volume On/Off
PB Pedal Bend On/Off
WAH Wah On/Off
PB/FV Pedal Bend, Foot Volume
WAH/FV Wah, Foot Volume
The currently selected setting is the one highlighted at the
lower right of the display.
For information on what settings you can assign, refer to "SW&PDL
FUNCTION" (p. 122).
] to switch pages.