Setting The Midi Omni Mode; Setting The Midi Transmit Channel; Setting The Midi Device Id; Setting The Midi Sync Clock - Boss GT-10 Owner's Manual

Chapter 6 Using the GT-10 with External MIDI Devices Connected

Setting the MIDI Omni Mode

This makes the settings for the channels used for MIDI information.
1. Follow the procedure in "Making the Settings for MIDI Functions" (p. 80) to
move the cursor to "Omni Mode."
2.
Set the desired
Omni On
value.
Omni Off

Setting the MIDI Transmit Channel

This sets the MIDI channel used for transmitting MIDI messages.
1. Follow the procedure in "Making the Settings for MIDI Functions" (p. 80) to
move the cursor to "Tx Channel."
2.
Set the desired
value.
1–16, Rx

Setting the MIDI Device ID

This sets the MIDI Device ID used for transmitting and receiving Exclusive messages.
1. Follow the procedure in "Making the Settings for MIDI Functions" (p. 80) to
move the cursor to "Device ID."
2.
Set the desired
value.
1–32

Setting the MIDI Sync Clock

This setting determines the basis used for synchronizing the timing for effect modulation rates and other time-based parameters.
1. Follow the procedure in "Making the Settings for MIDI Functions" (p. 80) to
move the cursor to "Sync Clock."
Auto
2.
Set the desired
value.
Internal
Messages are received on all channels, regardless of
the MIDI channel settings.
Information is received on the channel specified by
the Rx Channel setting.
Operations are synchronized to the MIDI Clock re-
ceived via MIDI. However, operations are automati-
cally synchronized to the GT-10's internal Clock if
the GT-10 is unable to receive the external Clock.
Operations are synchronized to the GT-10's internal
Clock.
• Even when Omni Mode is set to "Omni On",
the only Exclusive messages received are for
Device ID data set with "Device ID."
• When set to "Rx," this MIDI channel is same as
the MIDI Receive channel.
• When you have an external MIDI device
connected, the Master BPM is then
synchronized to the external MIDI device's
tempo, thus disabling the Master BPM setting.
To enable setting of the Master BPM, set to
"Internal."
• When synchronizing performances to the MIDI
Clock signal from an external MIDI device,
timing problems in the performance may occur
due to errors in the MIDI Clock.
81