Setting Each Controller Functions To Individual Patches (Assign) - Boss GT-10 Owner's Manual

Chapter 4 Playing Sounds

Setting Each Controller Functions to Individual Patches (Assign)

You can set the CTL/EXP Pedal, EXP PEDAL SW, and external controllers (footswitch and expression pedal) connected to the
rear panel's EXP PEDAL 2/CTL 3,4 jacks for each individual patch.
You can save up to eight separate settings per patch (using Assign numbers 1 through 8) that determine what parameters are
controlled by which controllers.
* Set the Prefernc parameter of the CTL/EXP Pedal and EXP PEDAL SW (p. 137) settings to "Patch."
Quick Settings
When you select prepared settings (Quick Settings), the relevant parameters are instantly set to their optimal values. This lets you
make the settings simply, instead of setting each individual parameter separately.
1. The MST/PDL FX screen appears.
Select ASSIGN.
2.
The ASSIGN screen appears.
3.
4.
Select one of the ASSIGN number (No.1–8).
5. Set the selected Assign number to "On."
Select the Quick Setting (P01–P08, U01–U10).
6.
Display Explanation
Quick:U**
Quick:P**
U01-1.1–U50-4.8
P01-1.1–P50-4.8
7. To use the Quick Settings with other Assigns, repeat Steps 4–6.
8. To save the settings, use the Write procedure (p. 42).
50
User Quick Settings
Preset Quick Settings
User Patch
When you select a User patch or Preset patch, you can use the existing patch's assign
Preset Patch
settings just as they are.
Each time [MASTER/PEDAL FX] is pressed it
alternately switches the selected ASSIGN number
on and off. When on, the Assign number at the
bottom left of the display and the "ON" indication
at the bottom right are highlighted. Be sure to set
any Assign settings not being used to "Off."