Turning On The Power; The Icons In The Play Screen - Boss GT-10 Owner's Manual

Turning on the Power

Before turning on the power, confirm the following.
• Are all external devices properly connected?
• Is the volume on the GT-10, your amp, and all other connected devices turned down to the minimum level?
Once the connections have been completed, turn on power to your various devices in the order specified. By turning on devices in the wrong order, you risk causing
malfunction and/or damage to speakers and other devices.
The display changes, showing the following.
pears at this point is called the "Play screen."
1.
2. Turn on the power to any external effects processors → the guitar amp (power
amp).

The Icons in the Play Screen

Bank - Patch Number
Category Name
Patch Name
Displays the Master BPM (p. 122) value for each patch.
When the PREAMP Ch.Mode is set
to Single, preamp channel A is se-
lected.
When the PREAMP Ch.Mode is set
to Single, preamp channel B is select-
ed.
This is displayed when the PREAMP Ch.Mode is set to Dual Mono or Dual
L/R.
This is displayed when the PREAMP Solo Sw is Off.
This is displayed when the PREAMP Solo Sw is On.
Master BPM
OUTPUT SELECT setting
PREAMP Channel
On/off state of the
PREAMP Solo Sw
When the PREAMP Ch.Mode is set
to Dynamic, the display switches be-
tween A and B according to the input
level.
Chapter 1 Playing Sounds
• Upon power-up, the patch most recently
selected when the power was last turned off is
The screen that ap-
selected.
• This unit is equipped with a protection circuit.
A brief interval (a few seconds) after power up
is required before the unit will operate
normally.
• The explanations in this manual include
illustrations that depict what should typically
be shown by the display. Note, however, that
your unit may incorporate a newer, enhanced
version of the system (e.g., includes newer
sounds), so what you actually see in the
display may not always match what appears in
the manual.
For details on the OUTPUT SELECT icons, refer to
"Making Settings for a Connected Device (Output
Select)" (p. 24).
23