Sending Program Change Messages; Sending Exp Pedal Operations As Control Change Messages; Sending Exp Pedal Sw Operations As Control Change Messages; Sending External Exp Pedal Operations As Control Change Messages - Boss GT-10 Owner's Manual

Chapter 6 Using the GT-10 with External MIDI Devices Connected

Sending Program Change Messages

This setting determines whether or not Program Change messages are output when patches are switched on the GT-10.
1. Follow the procedure in "Making the Settings for MIDI Functions" (p. 80) to
move the cursor to "PC Out."
2.
Set the desired
Off
value.
On

Sending EXP Pedal Operations as Control Change Messages

This sets the controller number when EXP Pedal operation data is output as Control Change messages.
1. Follow the procedure in "Making the Settings for MIDI Functions" (p. 80) to move
the cursor to "EXP1 Out."
2.
Set the desired Off
value.
CC#1–CC#31,
CC#64–CC#95

Sending EXP Pedal Sw Operations as Control Change Messages

This sets the controller number when EXP PEDAL SW operation data is output as Control Change messages.
1. Follow the procedure in "Making the Settings for MIDI Functions" (p. 80) to move
the cursor to "EXP Sw Out."
2.
Set the desired Off
value.
CC#1–CC#31,
CC#64–CC#95

Sending External EXP Pedal Operations as Control Change Messages

This sets the controller number when operation data from the EXP PEDAL connected to the EXP PEDAL 2 jack is output as
Control Change messages.
1. Follow the procedure in "Making the Settings for MIDI Functions" (p. 80) to move
the cursor to "EXP2 Out."
2.
Set the desired Off
value.
CC#1–CC#31,
CC#64–CC#95
82
Program Change messages are not output, even
when patches are switched.
Program Change messages are simultaneously out-
put when patches are switched.
Control Change messages are not output.
This sets the controller number when EXP Pedal op-
eration data is output as Control Change messages.
Control Change messages are not output.
This sets the controller number when EXP PEDAL
SW operation data is output as Control Change mes-
sages.
Control Change messages are not output.
This sets the controller number when external EXP
Pedal operation data is output as Control Change
messages.
• On the GT-10, Bank Select messages are output
simultaneously with Program Change
messages. For more details, refer to p. 85.