Phrase Loop Play; What's Phrase Loop; Using The Phrase Loop - Boss GT-10 Owner's Manual

Chapter 4 Playing Sounds

Phrase Loop Play

What's Phrase Loop?

In this mode, you can record up to 38 seconds of material (recorded in mono) and repeatedly play material as a "phrase loop." As
the loop plays, you can overdub new material if desired.
You can record a phrase loop with effects, or you can add effects after a loop has been recorded. Adding effects after-the-fact lets
you create special effects with recorded performances. It's also a great way to audition tones, as you can adjust effect parameters
in real time while a phrase plays back.

Using the Phrase Loop

Recording a Phrase (REC)
PHRASE LOOP
1.
2.
3.
Overdubbing Sound onto a Phrase (DUB)
1. Follow the procedure in "Recording a Phrase (REC)" (p. 58) to record a phrase,
then perform loop play. (The PLAY indicator lights up.)
Overdubbing starts. (The REC/DUB indicator lights up.)
Play the phrase you want to overdub along with the playback
2.
of the loop.
Overdubbing stops. (The REC/DUB indicator goes out.)
The phrase you just recorded is combined with the phrase
3.
you recorded first and that sound is automatically played in a
loop. (The PLAY indicator lights up.)
58
Press [BANK▼] and [BANK▲] at the same time.
The unit goes into recording standby (The REC/DUB indica-
tor flashes).
Recording starts. (The REC/DUB indicator lights up.)
Play the phrase you want to record.
Recording stops. (The REC/DUB indicator goes out.)
The recorded phrase is looped (played repeatedly). (The
PLAY indicator lights up.)
Simultaneously pressing these a second time stops
loop playback and switches Phrase Loop off.
The maximum recording time for monaural
recording is approximately 38 seconds. When the
recording time reaches 38 seconds, playback of the
recorded performance starts automatically.
Recording on top of an existing performance is
called "overdubbing."
If you want to overdub additional material, repeat
steps 2 and 3.