Chapter 6 Using the GT-10 with External MIDI Devices Connected
Transmitting Data to an External MIDI Device (Bulk Dump)
With the GT-10, you can use Exclusive messages to set another GT-10 to the same settings or to save effect sound settings to MIDI
sequencers and other such devices. This transmission of data is referred to as bulk dump.
Making the Connections
When Saving to a MIDI Sequencer
Connect as shown in the figure below, and put the sequencer in
the state where it is ready to receive Exclusive messages.
fig.08-140
M
MIDI IN
For instructions on operating the sequencer, refer to the owner's manual
for the sequencer you are using.
When Transmitting Data to Another GT-10
Connect as shown in the figure below, and match the Device ID
for the transmitting and receiving devices.
fig.08-150
87