Send/Return; Amp Control - Boss GT-10 Owner's Manual

Chapter 8 Parameters Guide

SEND/RETURN

This allows you to connect an external effects device to the
SEND and RETURN jacks and use it as part of the GT-10's
effects.
Parameter/ Explanation
Range
SEND/RETURN ON/OFF
Switches the SEND/RETURN on/off.
Off, On Pressing [MASTER/PEDAL FX] switches
On and Off.
Mode
Switches the SEND/RETURN mode.
Outputs the input to SEND/RETURN to
the SEND jack and the input from the RE-
TURN jack to the circuit post-SEND/RE-
TURN. Use this when you want to
connect an external effects device serially
Normal
in the GT-10's effects chain.
fig.04-0160
SEND
Outputs the input to SEND/RETURN to
the SEND jack, mixes the input from the
RETURN jack with the input to SEND/
RETURN (the direct sound), then outputs
this to the circuit post-SEND/RETURN.
Use this when you want to mix the GT-
10's effects sounds together with the
Direct Mix
sound with the external effects device ap-
plied to it.
fig.04-0170
SEND
Outputs the input to SEND/RETURN to
the SEND jack. The input from the RE-
TURN jack is disregarded. For example,
using this with the GT-10's reverb and de-
lay immediately ahead of the SEND/RE-
TURN allows you to use the SEND jack as
Branch Out
a direct out.
fig.04-0180
SEND
Send Lv
Adjusts the volume of the output to the
0–200
external effects device.
Return Lv
Adjusts the volume of the input from the
0–200
external effects device.
132

AMP CONTROL

By connecting your guitar amp's channel switching jack to the
GT-10's AMP CONTROL jack, you can then use Amp Control
to switch the amp channel.
This combining of the GT-10 and the amp channels allows you
to get an even wider variety of distortion sounds.
Since the Amp Control setting is handled as one of the effects
parameters saved to each individual patch, it allows you to
switch guitar amp channels with each patch.
Parameter/
Range
Amp Control
Off
RETURN
On
* To determine how the amp channels are switched when the
circuit is open and shorted, refer to the amp owner's manual, or
actually confirm the sounds by operating the amp.
* Note that, depending on the circuitry of the channel switching
jack in the guitar amp used, the Amp Control function may not
RETURN
operate.
• With Amp Control, not only can you switch amp channels, you can also
use it to switch the amp's effects on and off, like a footswitch controller.
• You can also switch this parameter using [MASTER/PEDAL FX] in the
AMP CONTROL screen.
Explanation
Guitar Amp
(amps channel switching jack) (AMP CONTROL jack)
Guitar Amp
(amps channel switching jack) (AMP CONTROL jack)
Short
GT-10
Open
GT-10