Changing The Connection Order Of Effects (Effect Chain) - Boss GT-10 Owner's Manual

Chapter 2 Creating Sounds (Patch Edit)

Changing the Connection Order of Effects (Effect Chain)

Here's how you can change the order in which the effects are connected.
The MST/PDL FX screen appears.
1.
Select FX CHAIN.
2.
The FX CHAIN screen appears.
3.
Select an effect you want to move.
4.
Pressing the effect button for the effect you want to move lets you choose the
effect.
Move an effect to the point where you want to have an effect inserted.
5.
6.
If you want to change the sequence further, repeat Steps 4 and 5.
Checking the Effect Level with the Level Meter
In the upper right of the FX CHAIN screen, you can meter the output level of each effect.
To check an effect's output level, move the cursor to the desired effect.
You can check the level of signals being input to the INPUT jack by selecting
Selecting allows you to check the level of signals output from the GT-10.
38
The icon displayed on the FX CHAIN screen
indicates the status as described below.
: Effect on
: Effect off
: Selected effect (movable)
: Selected effect (not movable)
• Pressing [CATEGORY/ENTER] or the
EFFECTS SELECT button for the currently
selected effect switches the effect on or off.
• You can choose effects on channel A (upper) or
channel B (lower) by using [
to switch between them.
• There are two effect routes—PREAMP channel
A and channel B—and [CHANNEL SELECT]
is used to select which one to use.
Channel A and channel B cannot be moved.
• If you want to name the patch or edit the name,
proceed to "Naming a Patch (PATCH NAME)"
(p. 41) before you save.
• If you want to save a name of the patch with
the settings you've made, proceed to "Saving a
Patch (PATCH WRITE)" (p. 42).
.
] and [ ]