Rap 5 Tray # Empty (C) - Xerox N2125N - DocuPrint B/W Laser Printer Service Manual

RAP 5 Tray # Empty (C5)
Procedure
The problem appears when using Tray 2 or Tray 3.
Y N
Check the paper level in Tray 1. There is paper in Tray 1.
Y N
Load paper into Tray 1.
Enter diagnostics and select Test Print. Run a test print from the Tray 1. The
code reappears.
Y N
Return to Initial Actions and restart.
Remove Tray 1 from the printer. Remove all paper from the tray. Reinsert Tray 1 into the
printer. From the rear of the printer, watch the Tray 1 bottom plate. The Bottom Plate is
raised fully and evenly.
Y N
Go to RAP 37.
Remove Tray 1. Manually actuate the Tray 1 No Paper sensor. The No Paper Actuator
moves smoothly.
Y N
Replace the Tray 1 No Paper Actuator
Enter diagnostics and select Component Test. Scroll to Sensor Input test and press Enter.
Manually actuate the Tray 1 No Paper Sensor. The number on the LCD increments
each time you press and release the actuator.
Y N
Go to RAP 34.
Replace the Print Engine Controller PWB
Check the paper level in Tray 2/3. There is paper in the Tray.
Y N
Load paper into Tray 2/3.
Enter diagnostics and select Test Print. Run a test print from Tray 2/3. The C5 error code
reappears.
Y N
Return to Initial Actions and restart.
Remove Tray 2/3 from the printer. Remove all paper from the tray. Reinsert the Tray into the
printer. From the rear of the printer, watch the tray bottom plate. The Bottom Plate is raised
fully and evenly.
Y N
Go to RAP 37.
Remove Tray 2/3. Manually actuate the No Paper Sensor. The No Paper Actuator moves
smoothly.
Y N
Replace the Tray 2/3 No Paper Actuator
A
Initial Issue
DocuPrint N2125
C5
(REP 3.3).
(REP 9.3).
(REP 11.7).
manuals4you.com manuals4you.com
A
Enter diagnostics and select Component Test. Scroll to Sensor Input test and press Enter.
Manually actuate the Tray 2/3 No Paper Sensor. The number on the LCD increments each
time you press and release one of the actuators.
Y N
Replace in order; the Feeder PWB
problem feeder assembly.
Replace the Print Engine Controller PWB
error
02/2000
2-15
(REP 11.9) then the Size PWB (REP 11.19) for the
(REP 9.3).
Status Indicator Repair Analysis Procedures
RAP 5