Rep 3.7 Feeder Assembly - Xerox N2125N - DocuPrint B/W Laser Printer Service Manual

REP 3.7 Feeder Assembly

Parts List on PL 3.1
Removal
WARNING
Switch off the power and disconnect the Power Cord.
1. Remove Tray 1.
2. Remove the Left Interface Cover Assembly
3. Remove the Left Cover (REP 1.2).
4. Remove the Front Cover Assembly (REP
5. Remove the Left Front Cover (REP 1.7).
6. Remove the Left Plate Assembly (REP
7. Remove the Plate Handle (REP 1.12).
8. Open Rear Door.
9. Remove the Top Cover Assembly (REP
10. Remove the Right Cover (REP 1.5).
11. Remove the LVPS PWB (REP 9.5).
12. Remove the Paper Feeder (REP 3.1).
13. Remove the Feed Clutch Assembly (REP
14. Remove the E-ring that secures the left shaft of the Feeder Assembly
15. Remove the left bearing from the left shaft of the Feeder Assembly
16. Open the Front Chute Assembly (Figure
NOTE: Caution: Don't lose Bias Spring located under the Feeder Assembly
17. Slide the Feeder Assembly to the right and remove
Figure 1 Feeder Assembly Bearing
Initial Issue
DocuPrint N2125
(REP 1.1).
1.6).
1.11).
1.4).
3.6)
(Figure 1).
(Figure 1).
2).
(Figure
(Figure 2).
Replacement
1. Reinstall the components in the reverse order.
2).
02/2000
4-23
manuals4you.com manuals4you.com
Figure 2 Feeder Assembly
Repair-Adjustment
REP 3.7