REP 6.1 Transport Chute Assembly
Parts List on
PL 6.1
Removal
WARNING
Switch off the power and disconnect the Power Cord.
1.
Remove Tray 1.
2.
Remove the Left Interface Cover Assembly
3.
Remove the Front Cover Assembly
(REP
4.
Remove the Left Front Cover
(REP
1.7).
5.
Remove the MBF Chute Assembly
(REP
6.
Remove the Paper Handler Assembly
7.
Remove the BTR Assembly
(REP
7.1).
8.
Remove the screw that secures the DTS Wire (white) to the Transport Chute Assembly
(Figure
1).
9.
Remove the screw that secures the TR Wire (red) to the Transport Chute Assembly
ure
1).
10. Use care not to drop high voltage contact springs when chute is removed
11. Remove the two screws that secure the Transport Chute Assembly to the printer
1). Remove Assembly.
Figure 1 Transport Chute Assembly
Replacement
1.
Reinstall the components in the reverse order.
Initial Issue
DocuPrint N2125
(REP
1.1).
1.6).
4.1).
(REP
5.1).
(Figure
REP 6.2 Fuser Assembly
Parts List on
PL 6.1
Removal
Switch off the power and disconnect the Power Cord.
The Fuser may be hot.
1.
Open the Rear Cover Assembly.
2.
Remove Duplex Assembly (if installed).
3.
Remove the two thumb screws that secure the Fuser Assembly to the printer and remove
the Fuser
(Figure
1).
(Fig-
1).
(Figure
Replacement
1.
Reinstall the components in the reverse order.
02/2000
4-43
manuals4you.com
manuals4you.com
WARNING
Figure 1 Fuser Assembly
Repair-Adjustment
REP 6.1, REP 6.2