Xerox N2125N - DocuPrint B/W Laser Printer Service Manual page 143

REP 6.3 Fuser Harness Assembly
Parts List on PL 6.1
Removal
Switch off the power and disconnect the Power Cord.
1. Remove Tray 1.
2. Remove the Left Interface Cover Assembly
3. Remove the Left Cover (REP 1.2).
4. Remove the Front Cover Assembly
5. Remove the Left Front Cover (REP
6. Remove the Left Plate Assembly (REP
7. Remove the Plate Handle (REP 1.12).
8. Open Rear Door.
9. Remove the Fuser Assembly (REP
10. Remove the Top Cover Assembly (REP
11. Remove the MBF Chute Assembly
12. Remove the Paper Handler Assembly
13. Remove the Transport Chute Assembly
14. Remove the Print Cartridge Top Guide Assembly
15. Remove the Print Engine Controller PWB
16. Remove the Main Motor Assembly
17. Remove the LVPS PWB (REP 9.5)
18. Remove the Drive Gear Assembly
19. Unplug the P/JPRB (red) from the HVPS PWB
20. Remove the screw that secures the HVPS Housing to the printer
21. Remove the HVPS.
22. Pull the Fuser Harness Assembly from the left side of the printer
23. Remove the two screws that secure the Fuser Harness Assembly to the printer
24. Remove the Fuser Harness Assembly.
Repair-Adjustment
REP 6.3
WARNING
(REP 1.1).
(REP 1.6).
1.7).
1.11).
6.2).
1.4).
(REP 4.1).
(REP 5.1)
(REP 6.1)
(REP 7.2).
(REP 9.3)
(REP 8.1)
(REP 8.2)
(REP 10.6).
(Figure 1).
(Figure 1).
Replacement
1. Reinstall the components in the reverse order.
(Figure 1).
02/2000
4-44
Figure 1 Fuser Harness Assembly
Initial Issue
DocuPrint N2125