Envelope Feeder - Xerox N2125N - DocuPrint B/W Laser Printer Service Manual

Table 4 Signal Names
Signal Name Description
/B Motor control signal
Signal: Pulse
Initial Issue
DocuPrint N2125

Envelope Feeder

Wiring Diagrams and Signal Information
This section of the manual contains a Block Diagram for the N2125 Envelope Feeder. The
Block Diagram shows the interconnections of the major subsystems within the printer. The
remainder of this section divides the Block Diagram into individual block diagrams to better
illustrate the electrical relationships between components and assemblies within the Envelope
Feeder. Each wire in the block diagram is tagged with a signal name, and each wire is termi-
nated at both ends with a pin number.
Block Diagram
1. Envelope Feeder Block Diagram
2. Print Engine Controller PWB <=> Connector PWB <=> Envelope PWB (Figure 3) (Table
2)
3. Envelope PWB <=> Envelope Exit Sensor Assembly, No Paper Sensor and Clutch (Figure
4)
Location of P/J Connectors
Use the P/J Table (Table 1) and the P/J map
the Feeder and Cassette.
To find the location of a P/J:
1. Locate the P/J connector number in the first column of the table.
2. Locate the corresponding coordinates in the second column, such as I7 or J7.
3. Go to the map.
4. Cross-reference the letter and number of the P/J coordinates with the letters and numbers
on the map.
5. The P/J connector is located within the area where the coordinates cross.
02/2000
7-33
manuals4you.com manuals4you.com
(Figure 1) to locate a specific P/J connector within
Offset Catch Tray, Envelope Feeder
Wiring Data