Rep 3.6 Feed Clutch Assembly - Xerox N2125N - DocuPrint B/W Laser Printer Service Manual

REP 3.6 Feed Clutch Assembly

Parts List on PL 3.1
Removal
Switch off the power and disconnect the Power Cord.
1. Remove Tray 1.
2. Remove the Left Interface Cover Assembly
3. Remove the Left Cover (REP 1.2).
4. Remove the Front Cover Assembly
5. Remove the Left Front Cover (REP
6. Remove the Left Plate Assembly (REP
7. Remove the Plate Handle (REP 1.12).
8. Open Rear Door.
9. Remove the Top Cover Assembly (REP
10. Remove the Right Cover (REP 1.5).
11. Remove the LVPS PWB (REP 9.5).
12. Remove the Paper Feeder (REP 3.1)
13. Remove the four screws that secure the bracket to the Paper Feeder and remove the
bracket (Figure 1).
14. Remove the Gear 3 and Gear 2 from the shaft of the Paper Feeder
15. Remove the E-ring that secures the Feed Clutch Assembly to the Feeder
16. Disconnect P/J651 from the clutch
17. Remove the Feed Clutch Assembly
Repair-Adjustment
REP 3.6
WARNING
(REP 1.1).
(REP 1.6).
1.7).
1.11).
1.4).
(Figure
(Figure
(Figure 2).
(Figure 2).
1).
2).
Replacement
1. Reinstall the components in the reverse order.
2. Ensure that all alignment pins are properly inserted in the bracket holes before replacing
the four screws.
02/2000
4-22
Figure 1 Paper Feeder Bracket
Figure 2 Feed Clutch Assembly
Initial Issue
DocuPrint N2125