GP 1.2 Safety Standards
N2125 satisfies the following safety standards: Table 1
Table 1 Safety Standards
Category
Standard Satisfied
Laser Safety
100V/120V type is submitted to FDA 21 CFR (Chapter
1, Subchapter J, Section 1010/1040).
220V/240V type is submitted to IEC 825 Class 1 laser
Product.
Ozone Density
Does not exceed 0.02 ppm of ozone density TWA
(Time Weight Average), measured according to ECMA
129 standard
Other standards
100V/120V type satisfies;-
UL 1950 3rd Edition, CSA C22.2 no. 950-M95 or equiv-
alent, NOM
200V/220V satisfies;-
IEC 950 including amendments 1,2,3 and 4, CE Direc-
tive 1, Nordic and other Agency Approval 2, CCIB
Note: 1. When the controller is installed, the OEM cus-
tomer shall be responsible for the submittal of CE and
CCIB.
2. The OEM customer shall be responsible for the Nor-
dic agency approvals including NEMKO, SEMKO, SETI
and DEMKO.
General Procedures / Information
GP 1.2 , GP 1.3
GP 1.3 First Print Output Time (FPOT)
The First Print Output Time is the time from when the printer receives a START signal in the
READY state, until a single page is printed and delivered into the output tray Table 1.
Tray 1 (sec)
Tray 2 (sec)
Paper
Size
Simplex
Duplex
Simplex
Letter
9.2
16.5
10.4
SEF
17.5
A4 SEF
9.3
16.8
10.5
18.6
NOTE:
1.
The data is the theoretical values when the paper is fed from tray 1.
2.
When Laser Motor OFF, the values are adjusted as follows:
•
FPOT = t + 4.0 seconds (600 dpi)
•
FPOT = t + 4.0 seconds (1200 dpi)
3.
When the paper is fed from other tray, the values are adjusted as follows:
•
FPOT = t - 1.2 seconds (from MBF)
•
FPOT = t + 1.2 seconds (from tray 2)
•
FPOT = t + 2.4 seconds (from tray 3)
4.
FPOT from the Sleep Mode add up to 65 seconds to each value.
02/2000
6-6
Table 1 FPOT
Tray 3 (sec)
MBF (sec)
Duplex
Simplex
Duplex
Simplex
17.7
11.6
18.9
9.2
18.7
19.9
18.0
11.7
19.2
9.3
19.8
21.0
DocuPrint N2125
Duplex
16.5
17.5
16.8
18.6
Initial Issue