Load Tray/Tray Empty - Xerox Phaser 6130 Service Manual

Error Messages and Codes

Load Tray/Tray Empty

3-60
No paper detected in tray.
Troubleshooting Reference Table
Applicable Parts
Left Side Harness Assy (PL3.1.18)
Photo Sensor (PL3.2.13)
Paper Feeder (PL3.1.3)
MCU Board (PL8.2.13)
Troubleshooting Procedure Table
Step Actions and Questions
Check the paper for loading and
1
setting
Check that the paper in use meets the
print job requirements
Does the error still occur after
reloading the paper and changing the
paper settings that the print job
requires?
2 Check the No Paper Actuator for shape
and operation
Pull the paper tray out.
Are the shape and operation of the No
Paper Actuator normal?
Check the Tray No Paper Sensor
3
(Photo Sensor) for operation
Pull the CASSETTE ASSY 250 out.
Perform the Tray No Paper test
(page 4-26): Service Mode > Engine
Diag > Sensor Test > Tray No Paper
Does the number on the screen
increase by one, when the actuator of
the Tray No Paper Sensor (Photo
Sensor) is operated?
Check the connectors of the Tray No
4
Paper Sensor (Photo Sensor) for
connection
Check the connections between the
MCU Board and Photo Sensor.
Are P/J23 and P/J234 connected
correctly?
Wiring and Plug/Jack Map References
"Map 2 - Laser Unit, Feeder Assembly"
on page 10-9
"Map 4 - Toner Dispenser Motors, HVPS,
MCU" on page 10-11
"Feeder, Manual Feed, & Registration" on
page 10-19
Yes
Go to step 2.
Go to step 3.
Replace the
MCU Board
(page 8-59).
Go to step 5.
Phaser 6130 Color Laser Printer Service Manual
No
Complete
Reseat the No
Paper Actuator.
If broken or
deformed,
replace the
Feeder
Assembly
(page 8-25).
Go to step 4.
Reconnect the
connector(s) P/
J23 and/or P/
J234 correctly.