Figure 2 Rear Roll Assembly
Replacement
1.
Reinstall the components in the reverse order.
Repair-Adjustment
REP 12.9, REP 12.10
REP 12.10 Middle Roll Assembly
Parts List on
PL 13.2
Removal
Switch off the power and disconnect the Power Cord.
1.
Remove the Duplex Assembly
2.
Remove the Turn Chute Assembly
3.
Remove the Duplex Cover
(REP
4.
Remove the Drive Cover
(REP
5.
Remove the Duplex PWB
(REP
6.
Remove the Connector Chute Assembly
7.
Remove the Motor Assembly
8.
Release the locking tab and remove the Middle Belt Stopper
9.
Remove the Synchronous Belt from the pulley.
10. Remove the Middle Duplex Gear
11. Remove 17 and 18 Gear
(Figure
12. Use a small screwdriver to release the left and right bearings
13. Lift the Middle Roll Assembly then move the roller to the left until the right end is free
ure
2).
14. Remove the Middle Roll Assembly
Figure 1 Locking Tab and Middle Belt Stopper
02/2000
4-98
WARNING
(REP
12.1).
(REP
12.2).
12.3).
12.5).
12.4).
(REP
12.6).
(REP
12.8).
(Figure
1).
(Figure
1).
1).
(Figure
1).
(Figure
2).
(Fig-
Initial Issue
DocuPrint N2125