Xerox N2125N - DocuPrint B/W Laser Printer Service Manual page 140

REP 5.6 Rubber Registration Roll
Parts List on PL 5.1
Removal
WARNING
Switch off the power and disconnect the Power Cord.
1. Remove Tray 1.
2. Remove the Left Interface Cover Assembly
3. Remove the Front Cover Assembly (REP
4. Remove the Left Front Cover (REP 1.7).
5. Remove the MBF Chute Assembly (REP
6. Remove the Paper Handler Assembly
7. Remove the Registration Clutch (REP
8. Remove the two E-rings that secure the two Registration Gears
9. Remove the E-ring from the left end of the Metal Registration Shaft
10. Release the two registration springs from the Metal Registration Roll
11. Squeeze and hold the Upper Chute and Inlet Chute together. Align the hole in the chute
with the Boss on the Left Bearing. Remove the Left Bearing from the Metal Registration
Roll (Figure 1).
12. Lift the Torsion Spring and slide the Right Bearing out. Squeeze and hold the Upper
Chute and Inlet Chute together and align the hole in the chute with the Boss on the Right
Bearing. Remove the Right Bearing (Figure
13. Slide the Metal Registration Shaft to the right and remove the assembly
14. Remove the left and right bearings from the Rubber Registration Roll
15. Lift the right end of the Rubber Registration Roll and remove
Initial Issue
DocuPrint N2125
(REP 1.1).
1.6).
4.1).
(REP 5.1).
5.5).
(Figure 1).
(Figure 1).
(Figure 2).
1).
(Figure 1).
(Figure 3).
(Figure 3).
02/2000
4-41
manuals4you.com manuals4you.com
Figure 1 Registration Roll
Repair-Adjustment
REP 5.6