Gp 3.8 Erase Cycle - Xerox N2125N - DocuPrint B/W Laser Printer Service Manual

• FUSER PAUSE command issued
Fuser Temperature Cycling (Table 1)
Table 1 Fuser Temperature Cycling
Temperature Name Temperature Value
High Trouble Temperature Approximately 215 C (Standby temperature + approximately
35 C)
Fuser Off Temperature Fuser control temperature +/- 0 C
Fuser Control Temperature Standby temperature (180 C)
(NVRAM Code 09=08)
Running temperature (180 C)
Fuser On Temperature Fuser control temperature - 2 C
Low Trouble Temperature Approximately 155 oC (Standby temperature - approximately
25 C)
General Procedures / Information
GP 3.7 , GP 3.8

GP 3.8 Erase Cycle

The printer immediately interrupts a print cycle whenever the Front or Rear Covers are opened,
there is a paper jam, Tray 1 is removed, or the printer power is switched off. When you remove
the cause of the print cycle interruption, such as closing the covers, clearing the paper jam,
reinstalling the Paper Tray, or switching on printer power, the printer runs an Erase Cycle before
continuing with the next print cycle.
During an Erase Cycle, the printer switches on the Main Motor Assembly and the BCR (AC and
DC), BTR(-) and DB (DC) voltages. The Erase Cycle removes any developed image (toner) on
the drum, and any latent image (electrical) on the drum. When the Erase Cycle finishes, the
printer returns to normal mode and is ready to resume printing.
02/2000
6-36
Initial Issue
DocuPrint N2125