Diagnosis Mode List - Mitsubishi Electric MR-J2S-CP Instruction Manual

7. DISPLAY AND OPERATION

7.3.2 Diagnosis mode list

Name
Sequence
External I/O signal
display
Output signal (DO)
forced output
Jog feed
Positioning
operation
Test
operation
mode
Motorless
operation
Machine
analyzer
operation
Software version Low
Software version High
For manufacturer
setting
Display
Refer to section 7.7.
Not ready.
Indicates that the servo amplifier is being initialized or an alarm
has occurred.
Ready.
Indicates that the servo was switched on after completion of
initialization and the servo amplifier is ready to operate.
Indicates the ON-OFF states of the external I/O signals.
The upper segments correspond to the input signals and the
lower segments to the output signals.
Lit: ON
Extinguished: OFF
The I/O signals can be changed using the MR Configurator (servo
configuration software).
The digital output signal can be forced on/off. (Refer to section
7.8)
Jog operation can be performed when there is no command from
the external command device. (Refer to section 7.9.2)
The MR Configurator (servo configuration software MRZJW3-
SETUP151E) is required for positioning operation. This operation
cannot be performed from the operation section of the servo
amplifier.
Positioning operation can be performed once when there is no
command from the external command device.
Without connection of the servo motor, the servo amplifier
provides output signals and displays the status as if the servo
motor is running actually in response to the external input
signal. (Refer to section 7.9.4)
Merely connecting the servo amplifier allows the resonance point
of the mechanical system to be measured.
The MR Configurator (servo configuration software MRZJW3-
SETUP151E or later) is required for machine analyzer operation.
Indicates the version of the software.
Indicates the system number of the software.
Manufacturer setting screen. Do not perform operation on this
screen.
7 - 6
Description