Mitsubishi Electric MR-J2S-CP Instruction Manual page 4

Melservo j2-super series
Table of Contents

Advertisement

4. Additional instructions
The following instructions should also be fully noted. Incorrect handling may cause a fault, injury, electric
shock, etc.
(1) Transportation and installation
Transport the products correctly according to their weights.
Stacking in excess of the specified number of products is not allowed.
Do not carry the servo motor by the cables, shaft or encoder.
Do not hold the front cover to transport the servo amplifier. The servo amplifier may drop.
Install the servo amplifier in a load-bearing place in accordance with the Instruction Manual.
Do not climb or stand on servo equipment. Do not put heavy objects on equipment.
The servo amplifier and servo motor must be installed in the specified direction.
Leave specified clearances between the servo amplifier and control enclosure walls or other equipment.
Do not install or operate the servo amplifier and servo motor which has been damaged or has any parts
missing.
Provide adequate protection to prevent screws and other conductive matter, oil and other combustible
matter from entering the servo amplifier and servo motor.
Do not drop or strike servo amplifier or servo motor. Isolate from all impact loads.
When you keep or use it, please fulfill the following environmental conditions.
Environment
In
Ambient
operation
temperature
In storage
Ambient
In operation
humidity
In storage
Ambience
Altitude
(Note)
Vibration
Note. Except the servo motor with reduction gear.
Servo amplifier
[ ] 0 to 55 (non-freezing)
[ ] 32 to 131 (non-freezing)
[ ]
20 to 65 (non-freezing)
[ ]
4 to 149 (non-freezing)
90%RH or less (non-condensing)
90%RH or less (non-condensing)
Indoors (no direct sunlight) Free from corrosive gas, flammable gas, oil mist, dust and dirt
Max. 1000m (3280 ft) above sea level
2
[m/s
]
5.9 or less
2
[ft/s
]
19.4 or less
CAUTION
Conditions
0 to 40 (non-freezing)
32 to 104 (non-freezing)
5 to 158 (non-freezing)
80%RH or less (non-condensing)
A - 3
Servo motor
15 to 70 (non-freezing)
HC-KFS Series
HC-MFS Series
X Y : 49
HC-UFS13 to 73
HC-SFS81
HC-SFS52 to 152
HC-SFS53 to 153
X Y : 24.5
HC-RFS Series
HC-UFS 72 152
HC-SFS121 201
X : 24.5
HC-SFS202 352
HC-SFS203 353
Y : 49
HC-UFS202
X : 24.5
HC-SFS301
Y : 29.4
HC-KFS Series
HC-MFS Series
X Y : 161
HC-UFS 13 to 73
HC-SFS81
HC-SFS52 to 152
HC-SFS53 to 153
X Y : 80
HC-RFS Series
HC-UFS 72 152
HC-SFS121 201
HC-SFS202 352
X : 80
HC-SFS203 353
Y : 161
HC-UFS202
X : 80
HC-SFS301
Y : 96

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents