Structure; Part Names - Mitsubishi Electric MR-J2S-CP Instruction Manual

1. FUNCTIONS AND CONFIGURATION

1.6 Structure

1.6.1 Part names

(1) MR-J2S-100CP or less
MODE
UP
Fixed part (2 places)
(For MR-J2S-70CP 100CP 3 places)
SET
DOWN
Name/Application
Battery holder
Contains the battery for absolute position data backup.
Battery connector (CON1)
Used to connect the battery for absolute position data
backup.
Display
The 5-digit, seven-segment LED shows the servo
status and alarm number.
Operation section
Used to perform status display, diagnostic, alarm,
parameter and point table setting operations.
UP DOWN
MODE
I/O signal connector (CN1A)
Used to connect digital I/O signals.
I/O signal connector (CN1B)
Used to connect digital I/O signals.
Communication connector (CN3)
Used to connect a command device (RS-422/RS-232C)
and output analog monitor data.
Name plate
Charge lamp
Lit to indicate that the main circuit is charged. While
this lamp is lit, do not reconnect the cables.
Encoder connector (CN2)
Used to connect the servo motor encoder.
Main circuit terminal block (TE1)
Used to connect the input power supply and servo
motor.
Control circuit terminal block (TE2)
Used to connect the control circuit power supply and
regenerative option.
Protective earth (PE) terminal (
Ground terminal.
1 - 15
SET
Used to set data.
Used to change the
display or data in each
mode.
Used to change the
mode.
)
Reference
Section4.5
Section4.5
Chapter7
Chapter7
Section3.3
Section3.3
Chapter6
Chapter15
Section14.1.4
Section1.4
Section3.3
Section14.1.4
Section3.7.2
Section12.1
Section3.7.2
Section12.1
Section14.1.1
Section3.10