Lucent Technologies MERLIN LEGEND System Manager's Manual page 112

Communications system release 5.0
Hide thumbs Also See for MERLIN LEGEND:
Table of Contents

Advertisement

MERLIN LEGEND Communications System Release 5.0
System Manager's Guide 555-650-118
3
System Components
Power-Related Hardware
Table 3–5.
Continued
Equipment
Loudspeaker Paging:
External paging system using DTMF
signaling. Customer paging systems
require an interface unit: for 3-wire
input, PagePal can be used.
Message-waiting indicator
Modem
2
Music On Hold:
Any FCC-registered 8-ohm music
source or recorded announcement
device.
SMDR Printer:
Must be located within 50 ft. (15 m) of
control unit or use Asynchronous Data
Unit (ADU); should be 1,200-bpi serial
printer set at no parity and one stop bit.
1.
Release 5.0 and later systems only; in earlier releases, a group can have only one primary
announcement device.
2.
If you use equipment that rebroadcasts music or other copyrighted materials, you may be
required to obtain a copyright license from and pay license fees to a third party such as
American Society of Composers, Artists, and Producers (ASCAP) or Broadcast Music
Incorporated (BMI). Or you can purchase a Magic on Hold system, which does not require
you to obtain such a license, from Lucent Technologies.
Power-Related Hardware
Your Lucent Technologies representative can plan for added power-related
hardware to provide your system with additional power and protection from power
surges, although most systems do not need extra surge protection. Other
accessories apply to system-specific conditions.
Power Accessories
In a power failure, battery backup units can keep the system running for several
hours. When you connect adjuncts and adapters to telephones, the power
requirements for the telephones and the system increase. Sometimes it is
necessary to add a power accessory, described in this section, to an individual
telephone or to the system to accommodate these additional needs.
Description
Connects to LS or GS/LS trunk jack.
Bidirectional paging supported; only one line jack
is needed for multizone paging.
Connects to single-line phones.
Can be connected to:
008 OPT, 016 (Release 4.0 and later), or 012 T/R
extension jack
MFM and MLX extension jack,
GPA and analog extension jack
Connects to LS or GS/LS trunk jack.
Music coupler required.
Connects to SMDR jack on processor module.
3
3
Issue 1
June 1997
Page 3-45

Advertisement

Table of Contents
loading

Table of Contents