Adding A Qcc Operator Position - Lucent Technologies MERLIN LEGEND System Manager's Manual

MERLIN LEGEND Communications System Release 5.0
System Manager's Guide 555-650-118
6 Managing the System

Adding a QCC Operator Position

o
Assign other buttons, for example, Night Service, Send/Remove Message,
Camp-On, headset, Auto Dial, Forward, Pickup, or Group Pickup, following
instructions in Chapter 5, "Centralized Telephone Programming," of
System Programming .
o
Program the telephone features following the instructions for each feature
in "Optional Telephone Features," "Optional Group Features," and "System
Features" in System Programming , Chapter 3, or in Chapter 5, "Centralized
Telephone Programming," of System Programming .
o
When you have finished, file the form(s) with the rest of the planning forms.
Programming Instructions
See the appropriate procedures in System Programming as noted in the task list
above.
Adding a QCC Operator Position
Use this procedure to add a QCC operator position (Hybrid/PBX systems only).
To add a DLC operator position, see the previous section,
Operator Position'' on page
Planning Guidelines
QCC operator positions can be assigned only to the first and fifth extension jacks
of an MLX module. The first jack on the first extension module in your system is
automatically assigned as the primary operator position.
A maximum of four QCC operator positions can be assigned.
When other QCC operator positions are added, the primary QCC operator
position should be the first one added.
Any combination of operator positions can be assigned as long as there are no
more than four QCC operator positions and no more than a total of eight operator
positions (see
6-57.
Table 6–11).
6
6
''Adding a DLC
6
Issue 1
June 1997
Page 6-60