Lucent Technologies MERLIN LEGEND System Manager's Manual page 258

MERLIN LEGEND Communications System Release 5.0
System Manager's Guide 555-650-118
6 Managing the System
Adding an Extension
Task List: Adding an Extension
o
Obtain Form 2a, System Numbering: Extension Jacks. Also obtain any
other relevant forms, including group-assigned feature forms (for example,
Form 7c, Group Coverage) and forms for the individual extension (for
example, Form 4d, MLX Telephone).
list of the planning forms.
o
On Form 2a, confirm that there is a spare jack that supports the type of
extension you want to add. In the Jack Type column, A indicates an analog
jack, D indicates a digital (MLX) jack, and B indicates a basic jack (for
single-line telephones, adjuncts, and certain applications).
o
Make decisions about which features and buttons to assign to this
extension as described in the planning guidelines above. Record your
decisions on the appropriate planning forms.
o
Open the System Programming menu from the console or a PC with SPM.
o
If your system uses the Set Up Space numbering plan (see Form 2a),
single-renumber the extension jack following the instructions in "Single
Renumbering" in the "System Renumbering" section of System
Programming , Chapter 3.
o
If you are adding a personal line, Loudspeaker Paging, or Pool buttons
(Hybrid/PBX only), assign the outside lines/trunks to the buttons on the
telephone, following the instructions in "Assign Trunks or Pools to
Telephones" in the "Telephones" section of System Programming ,
Chapter 3.
Also, you may choose to copy line/trunk button assignments, pool dial-out
code restrictions (Hybrid/PBX only), and Night Service information (for
operator positions only) as described in "Copy Line/Trunk Assignments" in
the "Telephones" section of System Programming , Chapter 3.
o
Assign Intercom or System Access buttons by following the instructions in
"Assign Intercom or System Access Buttons" in the "Telephones" section of
System Programming , Chapter 3.
NOTE:
If there are no spare jacks, you must add a module to the control unit
before you can add an extension. Contact your Lucent Technologies
representative.
NOTE:
This task requires Extension Forced Idle for this extension jack.
NOTE:
This task requires an idle condition: Extension Forced Idle.
6
Appendix D of this guide includes a
Issue 1
June 1997
Page 6-40