Messages Of The Software; Information Messages - Duerkopp Adler 869-M PREMIUM Operating Instructions Manual

144

10.2 Messages of the software

Please contact customer service if an error occurs that is not
described here. Do not attempt to correct the error yourself.

10.2.1 Information messages

Code Possible cause
3104 Pedal is not in position 0
3109 Operation lock
3110 Right thread tension
magnet not connected
3111 Left thread tension magnet
not connected
3150 Maintenance necessary
3354 Error during thread cutting • Perform software update
3383 Error during motor
referencing process
4201 SD card error
4430 OP3000 connection lost
4441 OP3000 DAC receiver
timeout
Operating Instructions 868-M PREMIUM - 02.0 - 01/2018
Troubleshooting
Remedial action
• When switching the control
on, take your foot off the
pedal.
• Check tilt sensor on machine
• Check the connection of the
right thread tension magnet
• Check the connection of the
left thread tension magnet
• Service is required
 Service Instructions
• Check motors
• Perform software update
• Insert SD card
• Replace the control
• Check connection to OP3000
• Replace OP3000
• Replace the control
• Check connection to OP3000
• Replace OP3000
• Replace the control