Table of Contents
Advertisement
1. Press the +/- Function buttons to set the value 4.
2. Press the Selection button.
3. Press the +/- Function buttons to set the coordinates for the 1st stitch
4. Press the Selection button.
5. Press the +/- Function buttons to set the coordinates for the 1st stitch
6. Press the +/- Program buttons to select the next stitch.
7. Repeat steps 3 to 5 for all further stitches.
8. Press the Ready button to memorize the modified sewing pattern.
9. Press the Reset button.
10.Press the USB button.
5.22 Error messages
In case of error, the LED in the Error button is lit.
Error message Description
E
8 Error
Table data
E
1 0 Error
Sewing pattern
number
E
3 0 Error
Needle bar position
top
E
4 0 Error
Sewing field
E
4 2 Error
scaling
E
4 5 Error
Seam pattern data
E
5 0 Pause
36
The Program display shows a 1 for the first stitch; the Function display
shows the value for the X-axis; the LED in the X-Axis icon is lit.
on the
X-axis.
The LED in the Y-Axis icon is lit; the Function display shows the value
for the Y-axis.
on the
Y-axis.
The LED in the button is unlit.
The LED in the button is unlit.
Potential cause
Unable to read the table
data
The selected sewing pat-
tern is not memorized in
ROM, or set to non-reada-
ble. The sewing pattern is
"0".
The needle bar is not at the
top position
Sewing field exceeded
The sewing length is below
10 mm
Seam pattern data are
implausible
Reset button pressed while
sewing.
Automatic sewing machine
stopped.
Settings via software
Remedy
• Memorize the table data again.
• Press the Reset button to confirm the sew-
ing pattern number.
• Check the connections.
• Turn the needle bar to the top dead centre
position.
• Press the reset button
• Check X/Y scaling.
• Press the reset button
• Check the sewing pattern and the X/Y scal-
ing.
• Press the reset button
• Check ROM.
• Press the reset button
• Actuate the thread trimmer.
• Restart the sewing operation.
Operating manual 512/532 Version 01.0 - 03/2013
Advertisement
Table of Contents
