Table of Contents
Advertisement
General information
1 General information
1.1 Scope of application of the manual
This manual describes the intended use and the set-up of the long arm
machine, H867.
It is valid for all submodels listed in Section 5 Technical data.
Operation of the drive is described in a separate operating manual.
1.2 Declaration of conformity
The machine complies with the European regulations specified in the dec-
laration of conformity or in the installation declaration.
1.3 Applicable documentation
The device contains built-in components of other manufacturers,
e.g. drive motors. The corresponding manufacturers have performed a
hazard assessment for these purchased parts and confirmed compliance
of the design with the European and national specifications. The intended
use of the built-in components is described in the corresponding manuals
of the manufacturers.
1.4 Damage during transport
Dürkopp Adler cannot be held liable for any damage during transport.
Check the delivered product immediately after receiving it. Report any
damage to the last transport manager. This also applies if the packaging
is not damaged.
Keep the machines, devices and packaging material in the condition they
were at the time when the damage was identified. That secures any claims
towards the transport company.
Report all other complaints to Dürkopp Adler immediately after receiving
the product.
1.5 Limitation of liability
All information and notes in this operating manual have been compiled in
accordance with the latest technology and the applicable standards and
regulations.
The manufacturer cannot be held liable for any damage due to:
• Failure to observe the operating manual
• Improper use
• Unauthorized modifications to the machine
• The deployment of untrained personnel
• Damage during transport
• Using spare parts not approved
Operating manual H867 Version 00.0 - Last updated: 01/2012
3
Advertisement
Table of Contents
