IV. INSTALLING THE
CONTROL CARD V
Caution:
Check to make sure that the MEMORY
TX/RX indicator is OFF before turning OFF
the main power switch.
1. Removing the Control Panel
1) Remove the following so that the inside cover
may be removed:
• Front door
• Fixing cover
• Drum unit (Release the developing assem-
bly.)
• Feeding assembly lever
• Registration roller knob
• Upper cassette
2) Remove the five screws, and remove the
inside cover.
3) Remove the following so that the control panel
may be removed:
• Fixing controller PCB (1 screw)
• Magnet plate from control panel top (1
screw)
• RS232C connector (1 screw)
4) Remove the four screws, and disconnect the
four connectors; then, remove the control
panel, and turn it over.
COPYRIGHT © 1996 CANON INC.
Download service manual and resetter printer at http://printer1.blogspot.com
2. Before Installation the Control
1) Remove the control card slot face plate q.
2) Remove the screw from the face plate w.
3) Remove the protection sheet from the display
CANON GP215/200 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON)
Card
1
Figure 5-401
2
Figure 5-402
of the Control Card V.
5. INSTALLATION
5–31