3Com 3C13636 Configuration Manual page 1334

3Com Router 3000 Ethernet Family
Configuration Guide
In the command, action is a behavior conducted to the packets, which includes the
following types:
discard: Drops the packet
remark-dscp-pass new-dscp: Sets new-dscp and transmit the packet.
remark-prec-pass new-precedence: Sets new-precedence of IP and transmit the
packet.
remark-mpls-exp-pass new-exp: Sets the new MPLS EXP and transmit the
packet.
pass: Transmits the packet.
The policy in which TP is used in traffic behavior on an interface can be used in the
input or output of the interface.
The policy in which TP is used in traffic behavior on an interface will cause the previous
qos car command ineffective on the interface.
If this command is frequently configured on the class of the same behavior, the last
configuration will replace the previous one.
The traffic configured with shaping and policing but without AF or EF behavior can be
sent if it passes the detection of policing or shaping. However, in case of congestion,
the traffic will enter the default queue.
XI. Configuring/deleting TS
Perform the following configurations in traffic behavior view.
Table 3-44 Configure/delete TS
Operation
Configure traffic shaping
Delete traffic shaping
When behavior including TS is used in the policy, it can only be used in the egress
interface.
When the policy with behavior including TS is applied on the interface, the qos gts
command configured on the interface will become invalid.
If this command is frequently configured on the same behavior, the last configuration
will replace the previous one.
The traffic configured with shaping and policing but without AF or EF behavior can be
sent if it passes the detection of policing or shaping. However, in case of congestion,
the traffic will enter the default queue.
gts cir committed-information-rate
committed-burst-size
[ queue-length queue-length ] ] ]
undo gts
3Com Corporation
3-28
Chapter 3 Congestion Management
Command
[ ebs excess-burst-size
[ cbs