Displaying And Debugging Custom-List Queue; Wfq Configuration - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
Table 3-15 Apply custom-list on the interface
Apply Custom-list on the interface
Cancel using CQ on the interface
Not CQ but FIFO is employed on the interface by default.
Caution:
Except for interfaces encapsulated with X.25 or LAPB, all physical interfaces can use
CQ.
You can apply CQ to a dialer interface. Before that, make sure the queuing
configuration on its physical interfaces is the default.
In addition, if these physical interfaces have had connections with their respective
connected devices, the applied queuing configuration cannot update to them
immediately. Instead, the configuration updates to the physical interfaces the next time
they set up connections.

3.4.3 Displaying and Debugging Custom-list Queue

After the above configuration, execute display commands in any view to display the
running of the custom-list queue configuration, and to verify the effect of the
configuration.
Table 3-16 Display custom-list queue status and application on the interfaces
Display custom-list queue status
Display
application status on the interfaces

3.5 WFQ Configuration

Configuring WFQ (Weighted Fair Queuing) includes:
Use WFQ or modify WFQ parameters
Operation
Operation
custom-list queue
3Com Corporation
3-15
Chapter 3 Congestion Management
Command
qos cq cql cql-index
undo qos cq
Command
display qos cql
display qos cq interface [ interface-type
interface-number ]