Configuring A Client (Basic Configuration) - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
IV. Configuring the map aging time
You can configure a map aging time on the DVPN server, so that the server can delete
maps related to unsuccessful registration. If a client successfully registers with the
server, the map for the client and the server coexists with the created session.
Perform the following configuration in system view.
Table 4-4 Configure the map aging time
Configure the map aging time
Restore the default map aging time
The default map aging time is 30 seconds.
V. Configuring a local user for a client
On a DVPN server that is configured to authenticate clients, you must configure a local
user and a password for each client. When registering with a DVPN server of this kind,
a client can pass the authentication only when the user name and password it provides
match those configured on the DVPN server.
Perform the following configuration in system view.
Table 4-5 Configure the user name and password for a client to use when registering
Create a local user
Remove a local user
Set a password for the local user (in
local user view)
Remove the password of the local user
(in local user view)
Configure a service for the user to use
Disable a service the user uses

4.2.2 Configuring a Client (Basic Configuration)

I. Enabling/disabling DVPN
Use these commands to enable/disable DVPN on a device. If you disable DVPN on a
DVPN server, the existing DVPN sessions are removed after they time out.
Operation
Operation
3Com Corporation
4-12
Command
dvpn server map age-time time
undo dvpn server map age-time
Command
local-user user-name
undo local-user { user-name | all }
password { cipher | simple } password
undo password
service-type { telnet | ssh | terminal |
pad | dvpn }
undo service-type { telnet | ssh | terminal
| pad | dvpn }
Chapter 4 DVPN