3Com 3C13636 Configuration Manual page 1316

3Com Router 3000 Ethernet Family
Configuration Guide
Table 3-3 Priority-list configuration based on network layer protocol
Configure
network layer protocol
Delete the relative classifying rules in
group-number
II. Configuring Priority-list based on interfaces on which packets are received
Classify the packets based on the ingress interfaces of Routers, and send them into
different queues.
Perform the following configuration in system view.
Table 3-4 Configure Priority-list based on interfaces on which packets are received
Configure
interfaces on which packets are received
Delete the relative classifying rules in
group-number
III. Configuring default queue
A default queue is designated for the packets that do not match any rules.
Perform the following configuration in system view.
Table 3-5 Configure default queue
Configure default queue
Restore the default value of default
queue
You may define multiple rules for a priority-list group and apply these rules to an
interface. When a packet that needs to be forwarded out the interface arrives at the
interface, the system compares it against the rule chain. If a match is found, the packet
is put into the corresponding queue and the match operation is complete; if no match is
found, the packet is put into the default queue.
Operation
priority-list according
Operation
Priority-list based
Operation
3Com Corporation
3-10
Chapter 3 Congestion Management
Command
qos pql
to protocol-name
queue { top | middle | normal |
bottom }
undo qos pql pql-index protocol
protocol-name [ queue-key key-value ]
Command
qos pql pql-index inbound-interface
on
interface-type interface-number queue
{ top | middle | normal | bottom }
undo qos
inbound-interface
interface-number
Command
qos pql pql-index default-queue { top |
middle | normal | bottom }
undo qos pql pql-index default-queue
pql-index protocol
queue-key key-value
pql pql-index
interface-type