Configuring Maximum Reserved Bandwidth; Displaying And Debugging Rtp Priority Queuing Configuration; Token Function Of Qos - 3Com 3C13636 Configuration Manual

Router 3000 ethernet family

Hide thumbs Also See for 3C13636:

Table of Contents

3Com Router 3000 Ethernet Family

Configuration Guide

Except for interfaces encapsulated with X.25 or LAPB, all physical interfaces can use

You can apply RTPQ to a dialer interface. Before that, make sure that the queuing

configuration on its physical interfaces is the default and their bandwidth is adequate.

3.7.2 Configuring Maximum Reserved Bandwidth

This command can set the max reserved bandwidth percentage of the available

Perform the following configurations in interface view.

Table 3-57 Configure bandwidth limitation

Configure bandwidth limitation

Restore the default value

The percentage argument is the percentage of the reserved bandwidth. It is in the

range of 1 to 100 and the default value is 80.

The following command can display the queue information of the current IP RTP Priority,

including the current RTP queue length and number of RTP packet dropping. It can

display the RTP priority queue configuration and statistics on an interface or on all

Perform the following configuration in any view.

Table 3-58 Display RTP priority queue configuration and statistics on an interface

Display configuration and statistics of

RTP priority queue on an interface

When FTP is used to transfer data, the upper layer protocol such as TCP provides the

flow control function. This can however cause the configuration of CQ and WFQ, if they

3Com Corporation

Chapter 3 Congestion Management

qos reserved-bandwidth pct percentage

undo qos reserved-bandwidth

[ interface-type interface-number ]

Table of Contents

3c13636-us - router 3036 3000 series