Configuring Features Of A Traffic Behavior - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
XIII. Defining or deleting an FR DE matching rule
Perform the following configuration in class view.
Table 3-32 Define or delete an FR DE matching rule
Define an FR DE matching rule
Delete the FR DE matching rule
The if-match fr-de command matches packets with the FR DE bit set to 1, while the
if-match not fr-de command matches packets with the FR DE bit left as 0.
XIV. Defining or deleting an outbound subinterface matching rule
Perform the following configuration in class view.
Table 3-33 Define or delete an outbound subinterface matching rule
Define
matching rule
Delete
matching rule
The interface specified in this command must support subinterfaces. At present, it can
be GE, FE, FR, or MFR only.
In addition, a policy containing a rule defined using this command must be applied to
the main interface where the specified subinterface is located. If the policy is applied to
a subinterface or to a PVC created on the main interface, the rule cannot take effect.

3.6.3 Configuring Features of a Traffic Behavior

To define a traffic behavior, you should first create a traffic behavior name and then
configure attributes for it in the new traffic behavior view.
I. Defining a traffic behavior and Entering traffic behavior view
Perform the following configuration in system view.
Operation
Operation
an outbound subinterface
an outbound subinterface
3Com Corporation
Chapter 3 Congestion Management
if-match [not] fr-de
undo if-match [not] fr-de
if-match
outbound-subinterface interface-type
interface-number.subinterface-number
undo if-match
outbound-subinterface interface-type
interface-number.subinterface-number
3-23
Command
Command
[ not
[ not
]
]