Rip Interface Configuration - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Reference Manual

RIP Interface Configuration

To display the following form, go to the RIP Interfaces Configuration form. Select a RIP interface number,
or open the RIP Interfaces folder and click Add RIP Interface.
The following table describes the RIP Interface Configuration controls:
RIP Interface Configuration controls
Table 160
Control
IP Interface number (1-255)
Enable RIP?
RIP Version
Default Route Action
Supply Route Updates?
Listen to Route Updates?
Descriptions
Assigns a numeric identifier to the RIP interface.
Enables or disables the RIP interface.
Configures the RIP version used by this interface. The default value is version 1.
When enabled, the switch accepts RIP default routes from other routers, but gives
them lower priority than configured default gateways. When disabled, the switch
rejects RIP default routes. The default value is disabled.
When enabled, the switch supplies routes to other routers. The default value is
disabled.
When enabled, the switch learns routes from other routers. The default value is
disabled.
Configuring the switch
225