Rip Interface Configuration - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Command Reference Manual

RIP Interface configuration

Command: /cfg/l3/rip/if <1-256>
[RIP Interface 1 Menu]
version
supply
listen
poison
split
trigg
mcast
default
metric
auth
key
enable
disable
current
NOTE: This menu is available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
The RIP Menu is used for configuring Routing Information Protocol parameters. This option is turned off by default.
NOTE: Do not configure RIP version 1 parameters if your routing equipment uses RIP version 2.
The following table describes the RIP Interface Configuration Menu options.
Table 132 RIP Interface Configuration Menu options
Command
version 1|2|both
supply disable|enable
listen disable|enable
poison disable|enable
split disable|enable
trigg disable|enable
mcast disable|enable
default disable|enable
metric <1-15>
auth none|password
key
enable
disable
cur
- Set RIP version
- Enable/disable supplying route updates
- Enable/disable listening to route updates
- Enable/disable poisoned reverse
- Enable/disable split horizon
- Enable/disable triggered updates
- Enable/disable multicast updates
- Set default route action
- Set metric
- Set authentication type
- Set authentication key
- Enable interface
- Disable interface
- Display current RIP interface configuration
Description
Configures the RIP version used by this interface.
The default value is version
When enabled, the switch supplies routes to other routers. This command is
enabled by default.
When enabled, the switch learns routes from other routers. This command is
enabled by default.
When enabled, the switch uses split horizon with poisoned reverse. When
disabled, the switch uses only split horizon. The default value is
Enables or disables split horizon. The default value is
Enables or disables Triggered Updates. Triggered Updates are used to speed
convergence. When enabled, Triggered Updates force a router to send update
messages immediately, even if it is not yet time for the update message. The
default value is
disabled
Enables or disables multicast updates of the routing table (using address
224.0.0.9). The default value is
When enabled, the switch accepts RIP default routes from other routers, but
gives them lower priority than configured default gateways. When disabled,
the switch rejects RIP default routes. The default value is
Configures the route metric, which indicates the relative distance to the
destination. The default value is
Configures the authentication type. The default is
Configures the authentication key password.
Enables this RIP interface.
Disables this RIP interface.
Displays the current RIP configuration.
.
2
enabled
.
.
enabled
disabled
.
1
.
none
Configuration Menu 129
.
disabled
.
.