Routing Information Protocol Configuration; Rip Interface Configuration - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Cli Reference Manual

Routing Information Protocol configuration

The RIP commands are used for configuring Routing Information Protocol parameters. This option is turned
off by default.
The following table describes the basic RIP Configuration commands. The following section provides more
detailed information and commands.
RIP Configuration commands
Table 128
Command
router rip
timers update {<1-120>}
enable
no enable
show ip rip

RIP Interface configuration

The RIP commands are used for configuring Routing Information Protocol parameters. This option is turned
off by default.
NOTE:
Do not configure RIP version 1 parameters if your routing equipment uses RIP version 2.
The following table describes the RIP Interface Configuration commands.
RIP Interface Configuration commands
Table 129
Command
ip rip version {1|2|both}
[no] ip rip supply
[no] ip rip listen
Description
Enter router RIP configuration mode.
Command mode: Global configuration
Configures the time interval for sending for RIP table updates, in seconds.
The default value is 30 seconds.
Command mode: Router RIP
Globally turns RIP on.
Command mode: Router RIP
Globally turns RIP off.
Command mode: Router RIP
Displays the current RIP configuration.
Command mode: All except User EXEC
Description
Configures the RIP version used by this interface.
The default value is version 2.
Command mode: Interface IP
When enabled, the switch supplies routes to other routers. This
command is enabled by default.
Command mode: Interface IP
When enabled, the switch learns routes from other routers. This
command is enabled by default.
Command mode: Interface IP
Configuration Commands
142