Network Protocol Setup Messages - Xerox 2006NPC - DocuColor Color Laser User Manual

24. Problem Solving

Network Protocol Setup messages

The following table lists the network protocol messages that you may see
during the Network Protocol setup. It also contains the last Setup screen
shown before the message appeared, a description of the problem, and any
action required.
Message
No AppleTalk zone
found.
You must first
enable a network
port.
Invalid frame size
Warning IPX
network number is
zero.
Can't detect Token
Ring hardware.
24-44
Setup screen
Enable AppleTalk
(Network Protocol
Setup>
AppleTalk Setup)
Protocol Setup or
Service Setup
(Network Setup)
Frame Type selection
(Network Protocol
Setup>
IPX>SPX Setup)
Frame Type selection
(Network Protocol
Setup>
IPX>SPX Setup)
Frame Type selection
(Network Protocol
Network Problem Solving
Description and action
The Ethernet network cable
is not attached to the
connector on the DocuColor
2006 or the network cable is
not plugged into the hub or
network. If your AppleTalk
network has zones, and you
want to specify a zone for the
Printer, you must connect the
network cable to the
DocuColor 2006 before
performing AppleTalk Setup.
AppleTalk network does not
have zones. Zones are not
required for printing to the
DocuColor 2006. Press OK
to continue.
Enable at least one network
port (Ethernet or Token Ring) in
Port Setup before beginning
Protocol Setup or Service
Setup.
The network hub is not
connected to a Novell server
when the DocuColor 2006 tries
to bind.
No other IPX computer can be
found on the network, or the
network hub is not connected
to the network when the
DocuColor 2006 tries to bind.
When this occurs, the network
number defaults to zero.
The Printer queries the Token
Ring hardware. Either some
Xerox DocuColor 2006