Reduce/Enlarge Presets; Connectivity & Network Setup - Xerox D95 System Administration Manual

System Settings
Inch Size
Select from 11 different inch-series sizes.
Others
If you select this option, you can then select from 14 other sizes.
Custom Size
If you select this option, you can enter any size. Set the width from 15-432 mm, and the
height between 15-297 mm, in 1 mm increments.
Reduce/Enlarge Buttons
Select the default magnification setting for the Reduce/Enlarge (R/E) Buttons 3, 4, and
5:
These three buttons appear in the Reduce/Enlarge column on the Basic Copying tab
(Copy feature). You can select a specific magnification setting for buttons 3, 4, and 5.

Reduce/Enlarge Presets

From this screen you can select the default magnification levels. The selections made
here appear on the Preset% feature on the Reduce/Enlarge section (the More button)
on the Copy screen.
Use the following procedure to assign default magnification levels to the Reduce/Enlarge
buttons.
1. From the Copy Service Settings screen, select Reduce/Enlarge Presets.
2. Select the item to be set or changed, and select Change Settings.
Note
Select the up and down arrows to display the previous screen and the next screen.
3. Select the desired setting for that R/E Preset.
4. Select Save to return to the Reduce/Enlarge Presets screen.
5. Repeat Steps 1-4 until you have assigned a magnification level to each of the R/E
Presets.
6. Select Close to return to the Copy Service Settings screen.
Connectivity & Network Setup
In Connectivity & Network Setup, you select the default network settings by which the
machine is connected and communicates to the client PCs and the parameters required
for the communications between the machine and its networked clients.
10-44 Xerox ® D95/D110/D125/D136 Copier/Printer
System Administration Guide