Network Setup - Xerox 2006NPC - DocuColor Color Laser User Manual

Docucolor 2006 user guide
Hide thumbs Also See for 2006NPC - DocuColor Color Laser:
Table of Contents

Advertisement

19. Performing the setup from WebSetup

Network Setup

Network Setup configures the printer to receive print jobs over the
networks that are used at your site. If the printer is configured to
enable more than one protocol, it automatically switches to the correct
protocol when it receives a print job. When the parallel port and one or
two network ports are enabled, print jobs can be received over all ports
at the same time.
You can view and specify the following network settings in Network
Setup:
Adapters and ports—View currently configured network adapters and
port settings.
From local Setup only, the installed network boards are displayed.
You cannot change this information. From remote Setup, you can
enable Ethernet or Token Ring. You can also enable the parallel
port, regardless of the network type you use.
Protocols—including AppleTalk, IPX/SPX and TCP/IP.
Print Services—including LPD printing (TCP/IP), NetWare printing
(PServer), Windows print sharing (SMB), HTTP support (WWW),
and Port 9100 printing.
Once you enter IP addresses, the server will store them, even if you
later disable TCP/IP. If you need to assign the printer IP address to
another drive, set the address to a null address.
In Network Setup, you can specify settings on the following tabs: Port,
Protocol1, Protocol2, Service1, and Service2.
19–8
Xerox DocuColor 2006

Advertisement

Table of Contents
loading

This manual is also suitable for:

Docucolor 2006

Table of Contents