Installing User Software In A Windows Nt 4.0 Environment - Xerox 2006NPC - DocuColor Color Laser User Manual

11
Use the following instructions to install software and set up printing
from Windows NT 4.0. Ensure that your printer is properly connect and
configured for your network. For details, refer to the chapters
Connecting to the network and Performing the setup from the Printer
Control Panel
Use the contents of this chapter as follows:
• Depending on your configuration, use one of the following sections
to install printer drivers and set up appropriate connections:
• Specify printer options with the section Setting the printer options.
• If necessary, refer to the section Installing additional software for
Windows NT 4.0.
All necessary files are included on the User Software CD.
In addition to using the User Software CD, you can download printer
drivers from the printer to your workstation with the Installer WebTool
(if the system administrator has enabled Internet access to the printer).
You can then install the drivers from your workstation. For instructions,
refer to the section Using the Installer WebTool in the chapter Using
the Fiery WebTools. After you download the printer files, the
installation process is identical to installing from the User Software CD.
Xerox DocuColor 2006
Windows NT 4.0 environment
• Parallel port printing
• TCP/IP and LPR printing
• IPX printing
• SMB printing
Installing user software in a
11–1 1