Xerox 2006NPC - DocuColor Color Laser User Manual page 260

11. Installing user software in a Windows NT 4.0 environment
Installing user software for SMB printing
Use SMB or WINS printing if you do not have a Novell network.
Printing by this method enables printing from a workstation to a
particular print connection (Hold, Print, or Direct) on the DocuColor
2006. The following procedure assumes you have the TCP/IP protocol
and Microsoft TCP/IP Printing software installed on the Windows NT
workstation.
You must install a new printer for each additional connection. Repeat
this procedure for each and assign each printer a descriptive name
during the printer driver installation for easy identification later.
In WebSetup and on the Configuration Page, SMB printing is referred to as
Windows Printing Service.
Before you continue, print a configuration sheet at the printer to obtain
the IP address assigned to the DocuColor 2006, as well as the Subnet
mask and gateway address, if they are used.
1. Ensure the printer is configured for SMB printing. For more
information, refer to the chapter Performing the setup from the
Printer Control Panel.
2. At your workstation, double-click the Network Neighborhood
icon to display your network environment.
11–18
Xerox DocuColor 2006