Positioning The Originals; The Document Glass - Xerox 2006NPC - DocuColor Color Laser User Manual

Positioning the Originals

There are two ways to position originals on the DocuColor 2006: on the
Document Glass or in the Document Feeder.

The Document Glass

Perform the following steps to use the Document Glass:
1. Raise the Document Cover or the Document Feeder.
2. Align the original into the rear, left-hand corner of the Document Glass
face down. Place your original in the same orientation that the paper
supply is loaded in your selected paper tray.
For transparency sheets, tracing paper or other types of thin paper, place a
blank, white sheet over the original on the Document Glass.
For information on the Paper Supply feature, see Chapter 24, "Copy Features".
For information on loading paper into a paper tray, see Chapter 1, "Setting up
the DocuColor 2006".
Long Edge Feed (LEF)
3. Close the Document Cover or the Document Feeder.
CAUTION
When copying a thick document, do not force the document cover down. The
Document Glass may break if under too much pressure.
WARNING
If you must perform a copy operation with the document cover open, do not
look at the scanner light.
The maximum original size that the Document Glass can scan is 11 inch x 17
inch or A3 (297 mm x 420 mm).
If you should try to register an original document larger than the maximum
size on the Document Feeder, the image will be cut off on your copy output.
Xerox DocuColor 2006
21. Basic Copying
Short Edge Feed (SEF)
21–5