Saving The Running Configuration Settings; Reviewing The Configuration - Cisco 7604 Configuration Manual

Chapter 3 Configuring the Router for the First Time
Current configuration:
Current configuration : 3441 bytes
!
version 12.1
service timestamps debug datetime localtime
service timestamps log datetime localtime
no service password-encryption
!
hostname Router
!
boot buffersize 522200
boot system flash disk0:c6sup22-jsv-mz.121-5c.EX.bin
enable password lab
!
redundancy
main-cpu
auto-sync standard
ip subnet-zero
no ip finger
!
cns event-service server
!
<...output truncated...>
!
interface FastEthernet3/3
ip address 172.20.52.19 255.255.255.224
!
<...output truncated...>
!
line con 0
exec-timeout 0 0
transport input none
line vty 0 4
exec-timeout 0 0
password lab
login
transport input lat pad mop telnet rlogin udptn nasi
!
end
Router#

Saving the Running Configuration Settings

To store the configuration or changes to your startup configuration in NVRAM, enter the copy
running-config startup-config command at the privileged EXEC prompt (#) as follows:
Router# copy running-config startup-config
This command saves the configuration settings that you created in configuration mode. If you fail to do
this step, your configuration will be lost the next time you reload the system.

Reviewing the Configuration

To display information stored in NVRAM, enter the show startup-config EXEC command. The display
should be similar to the display from the show running-config EXEC command.
OL-4266-08
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
Configuring the Router
3-11