Displaying The Replication Mode Auto Detection Status; Displaying The Replication Mode Capabilities; Displaying Subnet Entries; Displaying The Ipv6 Multicast Summary - Cisco 7604 Configuration Manual

Using show Commands to Verify IPv6 Multicast Layer 3 Switching

Displaying the Replication Mode Auto Detection Status

This example shows how to display the replication mode auto detection status:
Router# show platform software ipv6-multicast capability | include detection
Auto-detection of Replication Mode : ON

Displaying the Replication Mode Capabilities

This example shows how to display the replication mode capabilities of the installed modules:
Router# show platform software ipv6-multicast capability | begin ^Slot
Slot Replication-Capability Replication-Mode
1 Ingress
2 Egress
6 Egress
8 Ingress

Displaying Subnet Entries

This example shows how to display subnet entries:
Router# show platform software ipv6-multicast connected
IPv6 Multicast Subnet entries
Flags : H - Installed in ACL-TCAM
Interface: Vlan20 [ H ]
Interface: Vlan10 [ H ]
Note

Displaying the IPv6 Multicast Summary

This example shows how to display the IPv6 multicast summary:
Router# show platform software ipv6-multicast summary
IPv6 Multicast Netflow SC summary on Slot[1]:
Shortcut Type
---------------------------+--------------
(S, G)
(*, G)
IPv6 Multicast FIB SC summary on Slot[1]:
Shortcut Type
---------------------------+--------------
(*, G/128)
(*, G/m)
IPv6 Multicast Netflow SC summary on Slot[6]:
Shortcut Type
---------------------------+--------------
(S, G)
(*, G)
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
27-6
Ingress
Ingress
Ingress
Ingress
X - Not installed in ACL-TCAM due to
label-full exception
S:20::1 G:FF00::
S:10::1 G:FF00::
In this example, there are subnet entries for VLAN 10 and VLAN 20.
Shortcut count
100
0
Shortcut count
10
47
Shortcut count
100
0
Chapter 27 Configuring IPv6 Multicast PFC3 and DFC3 Layer 3 Switching
OL-4266-08