Displaying Hardware Layer 3 Switching Statistics - Cisco 7604 Configuration Manual

Displaying Hardware Layer 3 Switching Statistics

Displaying Hardware Layer 3 Switching Statistics
Hardware Layer 3 switching statistics are obtained on a per-VLAN basis.
To display hardware Layer 3 switching statistics, perform this task:
Command
Router# show interfaces {{ type
{port-channel number }}
1. type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet
This example shows how to display hardware Layer 3 switching statistics:
Router# show interfaces gigabitethernet 9/5 | include Switched
L2 Switched: ucast: 8199 pkt, 1362060 bytes - mcast: 6980 pkt, 371952 bytes
L3 in Switched: ucast: 0 pkt, 0 bytes - mcast: 0 pkt, 0 bytes mcast
L3 out Switched: ucast: 0 pkt, 0 bytes - mcast: 0 pkt, 0 bytes
To display adjacency table information, perform this task:
Command
Router# show adjacency [{{ type
{port-channel number }} | detail | internal | summary]
1. type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet
This example shows how to display adjacency statistics:
Router# show adjacency gigabitethernet 9/5 detail
Protocol Interface
IP
Adjacency statistics are updated approximately every 60 seconds.
Note
For additional information (including configuration examples and troubleshooting information), see the
Tip
documents listed on this page:
http://www.cisco.com/en/US/products/hw/routers/ps368/tsd_products_support_series_home.html
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
26-6
1
slot/port } |
1
slot/port } |
GigabitEthernet9/5
Chapter 26
Purpose
Displays hardware Layer 3 switching statistics.
Purpose
Displays adjacency table information. The optional detail
keyword displays detailed adjacency information, including
Layer 2 information.
Address
172.20.53.206(11)
504 packets, 6110 bytes
00605C865B82
000164F83FA50800
ARP 03:49:31
Configuring IP Unicast Layer 3 Switching
OL-4266-08