Table of Contents
Advertisement
Check the Running Configuration Settings
Procedure
Step 1
Connect a console terminal to the console port, and then boot the device.
Note
When this information appears, it means that you have successfully booted your device:
Example:
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
.
.
.
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]: yes
Press RETURN to get started!
Step 2
The first sections of the configuration script appear only at an initial system startup. On subsequent uses, the
script begins with a System Configuration Dialog as shown below. When prompted to enter the initial
configuration dialog, enter yes.
Would you like to enter the initial configuration dialog? [yes/no] yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity for management of the system,
extended setup will ask you to configure each interface on the system.
The basic management setup configures enough connectivity for managing the system; the extended setup
prompts you to configure each interface on the system.
Check the Running Configuration Settings
To view the value of the settings you have entered, enter the following command in privileged EXEC mode:
device# show running-config
To review the changes you have made to the configuration, enter the following command in EXEC mode and
copy run-start stored in the NVRAM.
device# show startup-config
Cisco ASR-920-20SZ-M Aggregation Services Router Hardware Installation Guide
56
The following is only an example of the output display; prompts may vary.
Configure the Device
Advertisement
Table of Contents
