Configuring The Supervisor Engine 2 And The Switch Fabric Module; Using The Slots On A Supervisor Engine - Cisco 7604 Configuration Manual

Configuring the Supervisor Engine 2 and the
Switch Fabric Module
This chapter describes how to configure the Supervisor Engine 2 and the Switch Fabric Module (SFM)
for the Cisco 7600 series routers.
Note •
•
This chapter consists of these sections:
•
•
•
•
For additional information (including configuration examples and troubleshooting information), see the
Tip
documents listed on this page:
http://www.cisco.com/en/US/products/hw/routers/ps368/tsd_products_support_series_home.html

Using the Slots on a Supervisor Engine 2

The Supervisor Engine 2 has one Flash PC card (PCMCIA) slot.
With PCMCIA Advanced Technology Attachment (ATA) FlashDisk devices, the keyword for the slot on
the active Supervisor Engine 2 is disk0: and the keyword for the slot on a redundant Supervisor Engine 2
is slavedisk0:.
With non-ATA Flash PC cards, the keyword for the slot on the active Supervisor Engine 2 is slot0: and
the keyword for the slot on a redundant Supervisor Engine 2 is slaveslot0:.
OL-4266-08
Release 12.2(18)SXE and rebuilds of Release 12.2(18)SXE do not support Supervisor Engine 2.
For complete syntax and usage information for the commands used in this chapter, refer to the Cisco
IOS Master Command List, Release 12.2SXat this URL:
http://www.cisco.com/en/US/docs/ios/mcl/122sxmcl/12_2sx_mcl_book.html
Using the Slots on a Supervisor Engine 2, page 6-1
Understanding How the Switch Fabric Module Works, page 6-2
Configuring the Switch Fabric Module, page 6-3
Monitoring the Switch Fabric Module, page 6-5
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
C H A P T E R
6
6-1